Chapter 2
Installing MightyBoard 800 Options
14
QuickStart Guide
MightyBoard 800
3. Disconnect any cables that would prevent you from accessing the DDR DIMM slot on the
MightyBoard 800.
4. If you need to remove the existing DDR DIMM from the DIMM slot before continuing, refer to
the previous procedure beginning with Step 5.
Refer to the Step 5 in the proceeding procedure,
Removing the DDR DIMM
, and follow the
remaining steps in that procedure before continuing with the next step in this procedure.
5. Remove the DDR DIMM from its protective bag, handling the DIMM by its edges.
NOTE
Ampro recommends using
PC2700 DDR 333 (166MHz, 6ns),
+2.5V, 184-pin, DDR RAM DIMM for maximum performance. The
MightyBoard will operate acceptably with a PC2100 DDR 266
(133MHz) DDR DIMM.
6. Ensure there is nothing in the DDR DIMM slot that would prevent its installation.
7. Ensure the two retaining latches are spread outward to accept the new DDR DIMM.
8. Align the notches on the DDR DIMM with the key on the DIMM slot, holding the DIMM at a
90
°
angle to the board. See Figure 2-3.
The DDR DIMM card edge and slot are keyed to install the DIMM into the slot in only one
direction.
Notch
Key
Retaining Latches (2)
DDR DIMM
DDR DIMM Slot
MB
800Q
kS
_
04b
Figure 2-3. Installing DDR DIMM into Slot
9. Insert the DIMM fully into the slot, handling the DIMM by its edges. See Figure 2-3.
The retaining latches should grasp the DIMM automatically if it is inserted properly. If the
latches do not fully close after you have installed the DIMM, the DIMM is not inserted correctly.
Содержание MightyBoard 800
