Ampro MightyBoard 800, Быстрый старт

Страница: 11 / 26

Chapter 1 Setting Up the MightyBoard 800
MightyBoard 800 QuickStart Guide 7
9) Check/Set the Power
Supply Input Voltage
•
If the ATX power supply uses auto-ranging operation at 50/60Hz, skip
this step.
•
Check the input voltage switch on the power supply located on the rear
of the ATX power supply just below the power connector.
The input voltage switch typically has two positions: 115 or 230 volts
– 115 volts is default position.
10) Verify the Jumper
Settings •
Check the jumper settings just in case a jumper has shifted during
shipping.
•
Refer to Figures 1-4 and 1-5 for the jumper locations and the Table 1-1,
located at the end of this chapter for the default jumper settings.
11) Power up the
MightyBoard 800 •
Plug the CRT monitor’s power cord into an AC outlet and turn on the
monitor.
• Plug the ATX power supply’s power cord into the AC outlet.
•
Turn the ATX power supply’s power switch to On before continuing.
•
Press the Green push-button switch on the Utility cable to power up
the MightyBoard 800.
12) Verify the
MightyBoard 800
powers-up satisfactorily
•
Verify the MightyBoard 800 passes POST successfully.
•
If a bootable device, or the desired operating system is not loaded on
one of the boot devices (floppy drive or CD-ROM) prior to power up,
you will see an error message “Disk boot failure, insert system disk
and press enter” near the end of the boot process. The boot process
stops until you intervene, by selecting from:
♦
Enter BIOS Setup using S for Setup or skip to Step 13.
♦
Press R to Reboot the system
♦
Turn off the power switch on the ATX power supply.
♦
Connect a bootable device to the MightyBoard 800, reapply
power to the system, and then skip to Step 13.
NOTE
Ampro does not recommend using a hard disk drive or CF card
with a preinstalled OS from another model computer to boot
the MightyBoard 800. This has proven to cause problems or
provide unreliable operation. Use a bootable device (floppy or
CD-ROM) to load the desired OS onto the hard drive (or CF)
and then the drivers, while still attached to the MightyBoard
800. Refer to Step 15.
NOTE
For the most current BIOS Information, refer to the Hardware
Release Notes provided as hard copy in the shipping container.
13) Enter BIOS Setup •
Press the <Del> key during POST, or S to enter BIOS Setup.
•
Use BIOS Setup during the initial boot to set the desired options
(time and date, alter the boot order of the floppy drive, CD-ROM,
hard disk drive, or select USB boot, LAN Boot, etc.).
•
Refer to the MightyBoard 800 Reference Manual for all of the
BIOS Setup options, including USB/LAN Boot options.
•
Refer to the next step to alter the boot sequence, while in Setup.