Chapter 2
Installing MightyBoard 800 Options
MightyBoard 800
QuickStart Guide
13
MB
800Q
k
S
_04a
Opened Retaining Latches (2)
DDR DIMM
DDR DIMM Slot
Figure 2-2. Removing DDR DIMM from Slot
Installing the DDR DIMM
If you want to install a larger size DDR DIMM or replace the existing DIMM, refer to the following
procedure.
1. Prepare the MightyBoard 800 for DDR DIMM installation:
♦
If the MightyBoard 800 is already prepared for DDR DIMM installation, with the power
turned off, the power cord disconnected, and an empty DIMM slot, skip to Step 4.
♦
If the MightyBoard 800 is operating, power down the system and continue with next step.
CAUTION
To prevent damage to the MightyBoard 800 and the DDR DIMM, ensure the power
switch on the power supply is turned off and the power cord has been removed from
the power source. The typical AT power supply will continue to provide standby
current to the board until the power cord is disconnected.
2. Disconnect the ATX power supply’s power cord from the power source.
CAUTION
To prevent damage to the DDR DIMM, do not touch the DIMM until you have
discharged yourself and followed good Electrostatic Discharge principals. The
DDR DIMMs are sensitive to static electricity and can be easily damaged by
improper handling. Do the following when handling a DDR DIMM:
Leave the DDR DIMM in the anti-static bag until you are ready to install it.
Use an anti-static wrist/ankle strap and a grounding mat connected to ground.
Before you remove a DDR DIMM from the anti-static bag, touch a grounded,
unpainted metal surface to discharge any static electricity.
Содержание MightyBoard 800
