2
3
5
6
4
8
7
1
Front View
Rear View
9
Parts Identification
PAGE 2
ZS5602 | UNINTERRUPTED PAGING SPEAKER ZONE SELECTOR
1. BGM FRONT PANEL ZONE SWITCH
These switches are for selecting zones for BGM broadcasting. Selection of BGM zones can only be made at these switches
and not from remote control panel.
2. PAGING FRONT PANEL ZONE SWITCH
3. ALL CALL PAGING SWITCH
4. DC POWER INPUT
This equipment operates using 24V DC supply with 1A rating. Should external overriding of volume controllers is
required, we suggest that a larger rating of supply is used, such as Amperes PS9400.
To page, use these switches and once pressed, it shall override the corresponding BGM zones to allow paging to be broad-
casted. A 24V DC signal of the zone would be sent out from the DC output port at the rear panel. Be sure to turn these
zones off at the front panel if a remote mic with zone selection is installed in the system.
Pressing ALL CALL switch shall activate all zones into paging mode, thus overriding all BGM broadcast. 24V DC shall
present at all zones for emergency overriding purpose.
5. EMERGENCY OVERRIDE RELAY CONTACT
This port shall be connected to EP1200A Emergency Paging Panel. Once activated, all zones shall be in Paging
mode and a dry contact is closed to enable connections for 24V DC supply to volume controllers for overriding
purpose.
If this port is utilised, we recommend that the 24V zone DC outputs port to be ignored.
6. REMOTE SELECT PORT
This can be directly connected to TD6240 decoder or PM1000 series paging mic for remote zone selection during
paging.
