10. POWER AND SINGAL LED
11. INCOMING AC SUPPLY
12. 24V DC INPUT CONNECTOR
13. SPEAKER OUTPUT TERMINALS
15. ALL CALL PORT
FM antenna terminal for media player.
14. PAGING MIC TERMINAL ( RJ45 )
16. ANTENNA PORT ( AVAILABLE FOR “P” SERIES ONLY )
17. LINE OUT XLR JACK
18. RCA JACKS FOR MUSIC SOURCES
19. MIC AND LINE SWITCH
For easy connection to PM1060. Activation of paging mic shall override the front selected zones.
LED indicator for power and signal outputs.
The mixer operates at 220 to 240 V ac. IEC connector with fuse rating of 3A is used.
MA2000 also operates on 24V DC. In PA installation, this shall be back up source in case of ac mains failure.
Under ac mains operation, DC voltage shall be on standby only.
20. XLR JACKS FOR INPUT SIGNALS ( CH 1 TO 4 )
All inputs to mixing amps shall use balanced signal with XLR jack. Use the mic / line switch for correct signal
level.
6 zones of speaker lines can be connected via these Phoenix connectors. 4 Ohm output is available but it is
advised to use only single type of speakers.
For connection to EP1200 emergency paging mic for highest all call priority paging, or other similar operation.
Stereo inputs for music sources for channel 5 and 6.
Channel 1 to 4 can be used with either line or mic level. Use this switch to connect to appropriate input level.
Parts Identifications
PAGE 3
MA2000 SERIES | MIXER AMPLIFIER WITH 6 ZONE OUTPUT
21. PHANTOM POWER SWITCH
Inputs 1 to 4 has switchable phantom power for usage with condenser microphones. The phantom power
voltage is 12V DC.
22. MUTE CONTROL KNOB
Ch 1 and 2 has higher priority than other channels. Ducking level can be adjusted via this knob. It can be turned
off by fully turning it clockwise. Adjust it according to your own preference.
Balanced output with +4 dBu ( or 1.2 V rms )
