REB175P
USER’S GUIDE
119
119
a.
Reboot the Range Extender / Bridge, wait 3 minutes for the Range Extender /Bridge to reconnect to
your network and try to access the Internet.
b.
The connection to your Source Network may have been dropped or the router settings may have
changed. Changes to the router could be a result of several events, such as a power outage. When this
occurs, connect to the Range Extender and access the setup menu using the web address:
http://setup.ampedwireless.com
. Run the Setup Wizard to reconnect the Range Extender to your
network.
c.
The Range Extender / Bridge may be too far from your Source Router and not maintaining a signal
strength of above 70%. Check the signal strength between the router and the Range Extender through
the web menu (left side): Dashboard > System Status. The Signal Strength readout will be under the
Source Wireless Network Settings section. This Signal Strength must be above 70%. If it is below,
move the Range Extender / Bridge closer to your router, or reposition the Range Extender / Bridge.
d.
Check that your antennas are fastened tightly to the antenna connectors.
e.
Rescan for another network by accessing
http://setup.ampedwireless.com
to connect to and repeat or
you may try to fix the issues with your Source Network and your home wireless router.
f.
Check to see that your home wireless router settings have not changed. Any changes to the SSID,
security, or channel number from the original settings will disconnect the Range Extender / Bridge’s
connection to the Source Network. To solve this simply run the Basic Setup Wizard again from the web
