Ampcontrol IPC1, Руководство пользователя

Страница: 17 / 53

IPC1 USER MANUAL ISSUE 9
-13-
MCR Close
Closure of the Main Contactor
Relay
Stopped
Stopping of the outlet by operation
of the local stop button
RTU Stop
Stopping of the outlet by operation
of the remote stop button
MC Opened
Main Contactor has opened but not
initiated by the IPC Relay
MC Fail
Main Contactor Fail Function Trip
CloseFail
Indicates that the MCI Input did
not close within 5 seconds of MCR
closing
EC

Trip Pilot/Earth continuity loop exceeds
45 Ohms
EC Leak T
Leakage resistance between the
pilot and earth is less than 1500
Ohms
EL Trip
Earth leakage protection tripped
EFLR Fail
Earth fault lock out test has failed
SC Trip
Trip condition of short circuit
protection
OC Trip
Trip condition of overcurrent or
overload protection
I bal-Trp
Current balance trip condition
RESET
Records resetting of a protection
trip function
Setup Mod
Records that set up data has been
modified
Fan I Stp
Outlet stopped by fan interlock
uVOLT Trp
Records that voltage was not
present on at least one outgoing
phase when the main contactor
was closed
MCF F Trp
Internal battery backed main
contactor fail trip
RTU ptc T
Operation of the remote
termination units PTC
T-mem Rst
Thermal memory has been
manually reset to zero
Mem.ERROR
Records that the relay’s non-
volatile parameter memory has
been corrupted

- P reset Internal microprocessor reset
Tmem Loss
The thermal memory data has been
corrupted
RTU mem. E
Records that the remote
termination unit’s non-volatile
memory has been corrupted or
remote termination unit has gone
off line while the outlet is running.
Outlet On
Records RTU machine code and
number when main contactor is
closed
(proceeded by MCR
closed). This log only appears
when in RTU mode.
RTU Off L Indicates a loss of communications
with the RTU.
Meg

Trp Insulation Test failed
IT: -- . -M

Records the result of the Insulation
Test
Insul . Alm
Result of Insulation Test is equal to
or less than the alarm level
10. Time & Date
If there is a need to adjust the real time clock, carry
out the following procedure:
1.
Using the Remote Display Module select the
time and date information page (Level 7,
Position 1) to display the Day, Month, Year,
Hours and Minutes.
2.
Press the enter key. A “v” will appear in the
top line above the minute section. This
indicates the number to be changed.
3.
Use the left and right arrow keys to move the
“v” to the desired position.
4.
Press the enter key. The “v” now changes to a
“?” The right arrow key is used to increment
the allowable values, once the desired value is
obtained, press the enter key again. The “?”
returns to a “v”.
5.
Repeat steps 3 and 4 until the correct time and
date is displayed.
- - - - - - - - - - - - -
MO 150595 09:46