www.amp-research.com
IM75163 rev 01.02.20
9/10
A M P R E S E A R C H P O W E R S T E P
T M
– S P R I N T E R
28
30
32
33
23
28
24
28
25
28
26
Measure from the front edge of door line on the pinch weld to the specified lengths below. Measure at 12”
for the front LED Light and 60” for the rear LED Light.
Affix lamp (16) to rocker panel surface. Make sure
lamp is affixed to a flat, clean surface.
Front Door:
Located in the loom in passenger foot well. Remove mat covering jack. Route Blue Trigger wire
up through opening in side of seat base. Route under floor paneling and route up towards foot well. Factory
wire will be Blue with a Green stripe
Drill a 9/32” hole through the pinch weld at marked
locations. Debur all holes.
