www.amp-research.com
IM75163 rev 01.02.20
5/10
A M P R E S E A R C H P O W E R S T E P
T M
– S P R I N T E R
1
2
3
5
Pre Drill holes with an 1/8” Drill and then drill to
17/32”.
Then insert rivet nuts into position. Refer
to install card in rivet nut tool bag.
Then pre
thread m8 screws and washers into position
Set template up to marked line. Center punch holes.
13mm
4
6
Rear Drive Linkage install:
Locate rear linkage
location. Clean undercoating so any proud edges
are knocked off and mounting surface is flat.
Set Upper mount up to bump in sheetmetal and
mark side of linkage near mounting slot.
Warning:
Rivet nuts not
properly collapsed will not
hold securely to sheet metal.
Set rear linkage over bolts. Using a 13mm box
wrench snug up two bolts on linkage.
Using supplied Flange bolts install bracket onto
Drive linkage Upper mount. Do not tighten to allow
for adjustment. Use shorter bolts to prevent bolt and
linkage arm interference.
13mm
