www.amp-research.com
IM75163 rev 01.02.20
6/10
A M P R E S E A R C H P O W E R S T E P
T M
– S P R I N T E R
1
2
3
4
7
9
10
11
18
Front Idler Linkage Install: Locate front linkage
mounting position. Location is approx 11” forward of
tab in unibody crossmember as show. Tape template
in place and center punch holes.
Pre Drill holes with an 1/8” Drill and then drill to
17/32”.
Then insert rivet nuts into position. Refer
to install card in rivet nut tool bag.
Then pre
thread m8 screws and washers into position
Warning:
Rivet nuts not
properly collapsed will not
hold securely to sheet metal.
Using supplied Flange bolts install bracket onto Idler
linkage Upper mount. Do not tighten to allow for
adjustment. Use shorter bolts to prevent bolt and
linkage arm interference.
13mm
Set front idler linkage over bolts. Using a 13mm box
wrench snug up two bolts on linkage.
13mm
Install Running board onto lower mounts. Measure 9 inches from end of board to side of linkage as shown
below.
9”
