User Guide - ATU
5 von 8
Technical Data are subject to change without
notice
User Guide ATU v.5.0 Test
kit.docx-5.0
Otherwise you will see a communication error.
5 Position measurement (ATU-1 and ATU-2)
-
Check the geometrical mounting conditions (use Mounting Instructions
https://www.amo-
gmbh.com/
-
If the ATU Box was connected successfully, you can start getting position with click at “Start”
button.
If something goes wrong during measurements, you will see error messages. Please follow the
instructions and try again.
-
To stop measurement process click “Stop” button.
-
If you need to set “0” position, click “Set current position as “0”” button. The button will change
name to “Reset “0” position” and the value in measurement data field will be set as 0. The value
of “0” position will be saved until you reset it by clicking the same button or close the programm.
-
Before closing programm, please break connection with ATU Box by clicking “Device connected”
button.
-
If an error occurs the textbox will change colors to red until the error is gone. The “ERROR
Acknowledge” button stays red until you press the button while there are no active errors.
