User Manual for AML Oceanographic’s Micro Pressure Sensor
AML OCEANOGRAPHIC
In-situ Real-time Detection Measurement
10
3.3 COMMAND SUMMARY
All commands are in the form of standard English words. Commands can be entered in
upper or lower case letters. The minimum letters of the command that the instrument will
recognize are enclosed in brackets. All commands are followed by an <
ENTER
> or
<
RET
>
Command:
VER
(Version)
This command will display the instrument header. The format is as follows;
Micro Pressure Sensor V1.11A SN:7016-P
>
Command:
RAW [RA]
This command will set the instrument to output RAW uncorrected data when using the
MONITOR, SCAN or DUMP commands.
Command:
REAL [RE]
This command will set the instrument to output Real corrected engineering data when using
the MONITOR or SCAN commands.
Command:
/ [/]
This command is used to toggle RAW and REAL modes of operation.
Command:
SCAN [S]
This command outputs one scan of data.
Command:
MON [M]
This command sets the instrument to continuously output data at the rate programmed with
the SET command
.
Pressing any key will discontinue the monitor command.
Command:
SET [SE] SAMPLE RATE [S]
This command sets the rate at which the instrument will take samples (or scans). The sample
rate is in the form of a number followed by the time units. The allowable time units are listed
below:
