Amit TE1088, Системное руководство, Страница: 28 / 135

Chapter 2 - Installation
2.3 Installation
The unit can be placed on a desktop or a shelf. Alternatively, it may be wall-
mounted.
For optimal performance, place the Networking Gateway in the center of
your office (or your home), in a location that is away from any potential
source of interference, such as a metal wall or microwave oven. This
location must be close to a mains outlet and network connections.
To install the Networking Gateway IDU:
1
Assemble an RJ-45 connector with a protective cover on the indoor end
of the IDU-ODU cable. The length of the IDU-ODU cable should not
exceed 100m. Refer to the relevant System Manual for instructions on
preparing the cable and for information on the cable type.
2
Connect the IDU-ODU cable to the ODU connector located on the rear
panel.
3
Connect the power cord of the transformer to the unit’s POWER socket,
located on the rear panel. Connect the Mains power cord to the power
transformer and to the AC mains.
NOTE
The color codes of the power cable are as follows:
Brown Phase ~
Blue Neutral 0
Yellow/Green Ground
4
When power is connected, the unit will automatically enter the self-test
phase. When it is in the self-test phase, the STATUS LED will be lit ON
for about 10 seconds, and will then blink 3 times, indicating that the
self-test operation has ended. Finally, the STATUS LED will blink
continuously one blink per second, indicating that the unit is
functioning properly.
5
Connect a PC to one of the LAN ports using an Ethernet cable and
configure the basic parameters of the SU-ODU. Align the antenna of the
ODU. For more information refer to the applicable sections of the
relevant System Manual.
6
Use a web browser to configure the parameters of the Networking
Gateway IDU. For details refer to Chapter 3.
Installation
14