46
EMERGENCY PROCEDURE
Every time when emergency situation occurs you should:
•
switch off the working assemblies of the plate
• disconnect power supply
• call in the service
•
as some minor faults can be removed by the user in accordance with the be low specified
instructions, before calling the Customer Service please go thro ugh the Table checking
every point.
PROBLEM
CAUSE
ACTION
1.The appliance is not wor king
- power supply failure
-check the in-house electric sys tem
fuse, replace if ne ces sa ry
2. The appliance does not re spond to
the entered settings
-control panel has not been swit-
ched on
- switch it on
- sensors have been to uched for less
than one se cond
- touch the sensors for a bit lon ger
- several sensors have been to uched
at the same time
- always touch only one sen sor
(except when switching off a hotplate)
3.The appliance does not re spond
and emits a short si gnal
- children lock has been
activated
- switch off the children lock
4.The appliance does not re spond
and emits a long si gnal
-improper operation (im pro per sen sors
have been to uched or pro per sensors
have been touched for too short time
- again activate the plate
- covered or dirty sensor (sen sors)
- uncover or clean the sen sors
5.The whole appliance swit ches off
- no settings have been en te red
within 10 seconds from swit ching
the plate on
- again switch on the control panel
and im me dia te ly enter the settings
- covered or dirty sensor (sen sors)
- uncover or clean the sen sors
6. One heating zone switches off,
and ”H” is on the display.
- limited time of operation
- again switch on the hot pla te
- covered or dirty sensor (sen sors)
- uncover or clean the sen sors
7.Residual temperature in di ca tor is
not lighted although the hot pla tes
are still hot
- power supply fa ilu re, the ap plian-
ce has been di scon nec ted from the
mains
-the residual temperature in di ca tor
will work again after swit ching the
control panel on and off.
8. Crack in the ceramic plate
Danger! Immediately disconnect the ceramic plate from the
mains (fuse) and call the nearest Customer Service Centre.
9. If the fault still remains
Disconnect the ceramic plate from the mains (fuse) and call the nearest
Customer Service Centre.
Important!
You are the person responsible for proper condition and operation of the
appliance in your household. If you call the Service for a fault which re-
sulted from improper operation, you will be charged with the costs of the visit
even during the period of warranty. We shall not be held liable for damages
caused by a failure to observe this Manual.
