- 66 -
TURN ON THE APPLIANCE
AND SELECT PROGRAMME
Turn on the appliance
1. Draw out the lower and upper basket, load the dishes and push them
back. It is commended to load the lower basket first, then the upper
one.
2. Pour in the detergent.
3. Insert the plug into the socket. Make sure that the water supply is
turned on to full pressure.
4. Open the door, press the Power button.
5. Choose a program, the response light will turn on. Then close the
door, the dishwasher will start its cycle.
Change programme
You can change the programme only if it runs for a short time. Other-
wise the detergent is already dissolved in water and the water could
be pumped out. In this case, refill the dispenser with detergent and
start the washing program from the beginning. To reset your dishwasher,
please follow the instructions below:
1. Open the door a little to stop the dishwasher, after the spray arm
stop working, you can open the door completely.
2. Press Program button for more 3 seconds to cancel the current pro-
gram and the machine goes into standby state.
3. You can change the program to the desired cycle setting.
Add dishes during the programme:
You can add extra dishes at any time before detergent is released. In this
case, follow the instructions below:
1. Open the door a little to stop the washing.
2. After the spray arms stop working, you can open the door completely.
3. Add the forgotten dishes.
4. Close the door, the dishwasher will continued to run after 10 seconds.
WARNING!
Be careful when opening the door during the dish-washing programme
as hot steam can be released and cause scalding.