- 56 -
• If you use the detergent properly and dishwasher settings are correct
you can save on salt and/or rinse aid.
• If dishwashing results while using 2-in-1 or 3-in-1 detergents are not
satisfactory (traces of lime scale on the dishes), please contact the
detergent manufacturer. The warranty does not cover complaints due
to the use of multi-component detergents.
Recommended use: For best results using multi-component cleaning
agents, add special salt and rinse aid in the dishwasher and set the water
hardness and amount of rinse aid to the lowest setting.
The solubility of the detergent tablets made by different manufacturers
can vary with regard to temperature and time. It is therefore not recom-
mended to use detergent tablets in quick programmes. It is recommend
-
ed to use powder detergents in quick programmes.
Always store detergents in a dry, cool place, out of reach of children. Add
detergent to the dispenser immediately before using the appliance.
Warning: If encounter another problem when using a multi-component
detergent, please contact the detergent manufacturer.
Stop using multi-component detergents
• Add special salt and rinse aid to dispensers.
• Set the water hardness to the highest level (6) and run an empty
dishwasher.
• Adjust the water hardness.
• Adjust rinse aid setting.
Warning: Use only rinse aid designed for domestic dishwashers. Wipe
up spilled rinse aid with a cloth as it will cause the formation of large
amounts of foam, and thus will reduce the dishwashing effectiveness.
Water hardness table
Water hardness
German degrees
[dH]
French degrees
[dF]
British degrees
[dE]
Water hardness
level indicator
Special salt con-
sumption
[g/cycle]
1
0~5
0~9
0~6
H1
0
2
6-11
10-20
7-14
H2
9
3
12-17
21-30
15-21
H3
12
4
18-22
31-40
22-28
H4
20
5
23-34
41-60
29-42
H5
30
6
35-55
61-98
43-69
H6
60
If the water hardness is higher than the maximum values given in the
table above, or if you use water from a deep well, it is recommended to
use filters and water treatment equipment.
NOTE: The factory settings are for the water hardness level 3.
Switch on the appliance;
Press the Start/Pause button for more than 5 seconds to start the water
softener set model within 60seconds after the appliance was switched
on;
Press the Start/Pause button to select the proper set according to your
local environment, the sets will change in the following sequence:
H1->H2->H3->H4->H5->H6;
Press the Power button to end the set up model.