19
VI. OPERATION INSTRUCTIONS
To lift vehicle
1.
Keep clean of site near the lift;
2.
Position lift arms to the lowest position;
3.
To shortest lift arms;
4.
Open lift arms;
5.
Position vehicle beside of the lifting arm, car should at the other side of the column;
6.
Move arms to the vehicle’s lifting point;
Note:
The four lift arms must at the same time contact the vehicle’s lifting point
where manufacturers recommended
7.
Press the start button of the power unit raise the lift until the rubber pad full contact
the car and ensure it’s safe.
8.
Continue raise the vehicle to the desired height and make sure the vehicle is steady
when the lift is rising, then release the button of the power unit.
9.
Press the release handle of the power unit to lower the lift onto the safety lock. Make
sure the safety device is on the normal working condition, then the vehicle is ready to
repair.
To lower vehicle
1. Be sure the clearance of around and under the
lift, only leaving operator in lift area;
2. Press the start button of the power unit to raise the vehicle slightly, and then open the
safety device, then lower the vehicle by pressing the release handle of the power unit;
3. Open the arms and position them to the shortest length;
4. Drive away the vehicle.
Содержание SML-6
Страница 1: ...SINGLE POST LIFT Model SML 6...
Страница 4: ...2 Arm Swings View Fig 2...
Страница 17: ...15 EXPLOEDED VIEW Model SML 6 Fig 24...
Страница 18: ...16 Manual Power Unit Fig 26 11V 60HZ 1 phase Cylinder exploded view Fig 25...
