AMGO Hydraulics PRO-12, Инструкция по установке и обслуживанию

Страница: 35 / 38

- 34 -
VI. OPERATION INSTRUCTIONS
To lift vehicle
1. Keep clean of environment near the lift;
2. Drive vehicle to the Platform and put on the brake;
3. Turn on the power and press the button
UP , raise the lift to the working position;
Note: make sure the vehicle is steady when the lift is raised.
4. Press the Handle of release valve to lock the lift in the safety position. Make sure the
Safety device is locked at the same height.
To lower vehicle
1. Be sure the clearance of around and under the lift, only leaving operator in lift area;
2. Press the button
UP the lift will be raised for 3-5 seconds, and then press the button
of Manual-controlled air valve by hand to make sure the safety device released,
press the handle of release valve by the other hand then the lift starts being lowered
automatically;
3. Drive away the vehicle when the lift is lowered to the lowest position.
4. Turn off the power.
VII. MAINTENANCE SCHEDULE
Monthly:
1. Re-torque the anchor bolts to 150 N·m;
2. Lubricate cable with lubricant;
3. Check all cable connection, bolts and pins to insure proper mounting;
4. Make a visual inspection of all hydraulic hoses/lines for possible wear or leakage;
5. Lubricate all Rollers, Safety devices with 90wt. gear oil or equivalent.
Note:
All anchor bolts should take full torque. If any of the bolts does not function for
any reason, DO NOT use the lift until the bolt has been replaced.
Every six months:
1. Make a visual inspection of all moving parts for possible wear, interference or
damage.
2. Check and adjust as necessary, equalizer tension to insure level lifting.
3. Check columns for plumbness.