A6 Quick Start: Hart
COMMUNICATIONS
Copyright
©
2016 A & H Enterprises, Inc.
All rights reserved
00000329-0900-014 * Rev. B, 06/16
Page 12 of 21
AMFLOW
®
ETHERNET COMMUNICATION SET-UP: OPTIONAL
Additionally, if an Ethernet connection is desired a cable must be
connected according to the diagram.
1. Connect TX + to Terminal Block 13.
3. Connect TX - to Terminal Block 14.
3. Connect RX + to Terminal Block 15.
4. Connect RX - to Terminal Block 16.
CAUTION
Parameters are pre-set at the manufacturer.
CONNECTING TO DEVICE:
S
TEPS
:
1. Connect Ethernet lines to actuator (this must be done before
power up).
2. Connect PC and Actuator to DHCP Router (WIFI must be
disabled).
3. Connect power supply lines to actuator.
4. Apply +24VDC power.
5. Connect to website with the address
, where xxxx
is the serial number of device.
The serial number may be found in two (2) locations:
a. Front of actuator cover
b. Junction box.
6. When prompted enter user name and password.
7. Allow device page to load; you should see the Link LED graphic
blinking.
8. Click on all pages, one at a time, to load initially; this may take
several seconds the first time pages are opened, after that
navigation between pages should be faster.
