Ametek Surtronic 25, Руководство пользователя

Страница: 28 / 60

Surtronic S25
To cancel a measurement
If Measure is pressed during a traverse, a stop and reversal without
measurement will occur and Measurement Cancelled is displayed.
Using the Surtronic 25 with a PC
If the Surtronic 25 is connected to a PC then measurements will be
taken in dump mode, which is selected using the Scroll and Select
keys from the main menu (see next chapter for full set-up details).
Position the Pickup stylus on the component to be measured.
Measurements are then activated from the software on the PC.
When the measurement is completed the pickup returns and the
results are dumped directly to the PC. During transfer of the
measurement data the message Data Dumping is displayed.
When the data dump is completed, the dump menu still remains
active. From the displayed menu, values of evaluation length and
range can be changed and further measurements for data dump can
be made (see next chapter for further details).
Printing
PRINT KEY:pressing this key causes the evaluated measure-
ment data to be output to the RS232 port. When a printer is
connected, a printout of all the parameters selected in the print
menu is made.
If SPC has been selected (see chapter 4) the heading is disabled.
Where the profile is longer than 80cm the printout will stop after
80cm. Pressing PRINT key can print the next 80cm. The printout
will start from the beginning of the profile if SELECT is activated.
If no legal surface data is stored, the error message "Measure
before print" is displayed.
Page 3-4