Ametek Sorensen DCS-E Series, Руководство по эксплуатации

Страница: 59 / 67

M362500-01 Rev K 4-1
SECTION 4
MAINTENANCE, TROUBLESHOOTING,
AND CALIBRATION
4.1 General
This section provides periodic maintenance, calibration and troubleshooting information.
4.2 Periodic Service
Routine service consists only of annual calibration and periodic cleaning. Whenever a unit is
removed from service, it should be cleaned, using denatured or isopropyl alcohol or an
equivalent solvent on the metal surfaces and a weak solution of soap and water for the front
panel. Low pressure compressed air may be used to blow dust from in and around components
on the printed circuit boards.
4.3 Troubleshooting
Units requiring repair during their warranty period should be returned to AMETEK
Programmable Power for service. Unauthorized repairs performed by anyone other than
AMETEK during the warranty period may void the warranty. Any questions regarding repair
should be directed to the Service Department of AMETEK Programmable Power, Inc.
WARNING
POTENTIALLY LETHAL VOLTAGES EXIST IN THE POWER CIRCUIT
AND THE OUTPUT OF HIGH VOLTAGE MODELS. Filter capacitors
store potentially dangerous energy for some time after power is removed.
Repairs should be attempted by experienced technical personnel only.
Be sure to isolate the power supply from the input line with an isolation
transformer when using grounded test equipment such as an oscilloscope
in the power circuit.