Ametek mocon Dansensor ISM-3, Руководство пользователя

Страница: 24 / 34

22 User Manual EN Dansensor
®
ISM-3
P/N 200114-I
09/2021
The display shows:
er. 1
Invalid programming
of the set-up menu Check within which range the set values
must be. See
“The setup menu
SET.
” on
page 15 for details.
The display shows:
er. 2
Programming outside
the valid range for the
Flush delay (
DEL.
)
parameter
The display shows:
er. 3
Invalid setting of
PA.
See "Setting up of options, relay and
external measurement control" on page 16
The display shows:
er. 4
An attempt has been
made to change
calibration gas No. 1
(20.946%O
2
). This gas is
reserved for
atmospheric air.
Select one of the other calibration gas
entries (where readout is 0ppm) for entry
of a new calibration gas.
The display shows:
er. 5
An attempt has been
made to enter two
calibration gases with
the same value Find the calibration gas with the same
value as the one you tried to enter and
calibrate
The display shows:
er. 6
An attempt has been
made to calibrate with
a 0ppm gas Type in a gas that is not 0.
The dispaly shows:
er. 7
The result of the offset
adjustment is too high
(> 10mV) Check that ISM-3 is only supplied with
atmospheric air during offset adjustment
The display shows:
er. 8
An attempt has been
made to calibrate with
an other gas than
20.946% O
2
(atmospheric air) after
offset adjustment has
been carried out
When offset adjustment has been carried
out, all calibrations are locked. See
"Calibration" on page 19 .
The display shows:
er.9
An attempt has been
made to calibrate or
adjust the offset where
measuremet has been
disabled or where
warm-up period has
not been completed. See "Calibration" on page 19 and/or "Offset
adjustment" on page 20 .
Problem Possible cause Possible solution