Ametek JOFRA HPC600, Руководство пользователя

Страница: 9 / 48

7
2.1.2 Main Menu Functionality
There are three options on the Menu, CONFIG, {Active Display} and MORE.
The Main Menu is home for the menu display.
2.1.2.1 Setting the Active Display
The active display is indicated by the center option on the Main Menu,
pressing the F2 key will toggle the active display.
2.1.2.2 Setting Active Display Parameters
To set the parameters of the active display use the CONFIG option to get to
the Display Configuration Menu.
Here the SELECT option will toggle through the choices for each parameter.
The first parameter is MODE. Since voltage, current and switch test modes
all use the same jacks, two of these functions cannot be used concurrently.
The ability to select certain functions is limited based on what is already
selected in another display. The NEXT option is used to change to the
second parameter. Only RTD and Pressure modes have a second
parameter, RTDs can be read in Celsius or Fahrenheit and Pressures can be
read in 15 engineering units.
With a single display the following modes are available:
P[1] = Pressure internal sensor.
[EXT] = Pressure with external pressure module.
P[1] ST = Switch Test with left side sensor.
[EXT] ST = Switch Test with external pressure module.
Note: mA functions are only available on the Lower Display.
mA MEASURE = Milliamps measure without loop power.
mA MEAS/24V = Milliamps measure with loop power.
mA SOURCE = Milliamps source.
mA SIM-2W = Milliamps simulate using an external supply from the UUT.
VOLTS = Voltage Measure.
RTD = RTD Temperature Measurement (if a probe is connected).