Ametek Chandler Engineering 8040D10, Инструкция по эксплуатации

Страница: 23 / 52

SECTION 3 – MAINTENANCE 3-7
MAINTENANCE SCHEDULE CONSISTOMETER
COMPONENT EACH TEST MONTHLY 3 MONTHS 6 MONTHS ANNUAL
Slurry Cup Disassemble,
clean, inspect
Potentiometer
Mechanism Clean, lube,
inspect Disassemble,
clean, lube, inspect
Mag Drive Disassemble,
clean, inspect
Oil Replace
Low Press. Filter Replace
High Pressure
Filter Disassemble,
clean, inspect
Replace
Cylinder Press.
Release Valve Replace
Air Operated Valve Disassemble,
replace needle,
seat
Pump Maintenance
performed by qualified
factory service
technician
Pressure Gauge

Calibration
Drive Motor

Set Speed
Temp. Controller
Thermocouple Inspect

Calibration Calibrated by qualified
factory service
technician
Timer

Calibration
Heater Tested by qualified
factory service
technician
Reservoir Clean-out by qualified
factory service
technician
Rupture Disk Replace
This maintenance schedule applies to normal usage conditions of two tests per day. Detailed procedures for these operations are
contained in your manual.

PER API SPEC REQUIREMENTS
σ
WHERE APPLICABLE