Page 4
For technical questions, please call 1-888-866-5797.
Item 64017
Sa
F
ety
Opera
ti
O
n
Maintenance
Setup
14� Do not operate Meter if under the
influence of alcohol or drugs� Read
warning labels on prescriptions to
determine if your judgment or reflexes
are impaired while taking drugs� If there
is any doubt, do not operate the Meter�
15� People with pacemakers should
consult their physician(s) before
use� Electromagnetic fields in close
proximity to heart pacemaker could
cause pacemaker interference
or pacemaker failure�
16� Do not test voltage on circuits higher
than 1000 VDC or 750 VAC�
17� Do not test current on circuits
higher than 1000A�
18� Dress properly� Protective,
electrically nonconductive
clothes and nonskid footwear are
recommended when working�
19� Wear ANSI-approved safety
goggles during use�
20� Only use accessories intended
for use with this Meter�
21� Avoid damaging Meter� Use only
as specified in this manual�
22� Prior to testing resistance, diodes,
or continuity; disconnect all power
to the circuit and discharge all
high-voltage capacitors�
23� Performance of this Meter may vary
depending on battery condition�
24� Use the proper settings, terminals,
techniques, and range for the
tests performed� Start with the
range stated in the instructions�
25� Do not apply voltage to the Test
Leads when the Meter is in the
Ohms testing setting� Damage
can occur to the Meter�
26� Do not switch between testing modes
with the Meter connected to a circuit�
27� Do not use the Meter at a setting
marked as blank on the scale�
28� Have Meter calibrated by a
qualified technician every year
to maintain accurate results�
29� Do not disassemble charger;
take it to a qualified technician
when service or repair is required�
Incorrect reassembly may result
in a risk of electric shock or fire�
30� The warnings, cautions, and
instructions discussed in this
instruction manual cannot cover all
possible conditions and situations
that may occur� It must be understood
by the operator that common sense
and caution are factors which cannot
be built into this product, but must
be supplied by the operator�
SaVe tHeSe inStructiOnS.
