3
240mm MAX.
(9-1/2) MAX.
-C-L-
-C-L-
51mm
(2)
70mm
(2-3/4) DIA.
25mm (1) MAX.
160mm
(6-1/4)
OVERRIDE
BUTTON
160mm
(6-1/4)
127mm X 127mm
(5X5 CUTOUT
FOR BOX)
128mm MAX.
(5) MAX.
400mm MAX.
(15-3/4) MAX.
FOR LOCATION OF INLET SUPPLY ON BACK INLET
FIXTURES AND CORRECT HEIGHT FROM FINISHED FLOOR,
REFER TO FIXTURE INSTRUCTION SHEET.
FINISHED
WALL
CONCEALED BACK
SPUD TOILET
EXPOSED BACK
SPUD TOILET
TOP SPUD
TOILET
TOP OF
FIXTURE
FINISHED
FLOOR
FINISHED
FLOOR
FINISHED
FLOOR
TOP OF
FIXTURE
SENSOR
SUPPLY
(1) NPT
108mm-134mm
(4-1/4 TO 5-1/4)
*Note: The Critical Line (-C-L-) on Vacuum
Breaker must typically be 6
" (152mm) min.
above fixture. Consult Codes for details.
51mm
(2)
51mm
(2)
WALL THICKNESS
15˚
TOP OF
FIXTURE
450mm MAX.
(17-3/4) MAX.
DETECTION ZONE
400mm-800mm
(Factory Setting: 400mm)
152mm MIN.
(6) MIN.
*-C-L-
152mm MIN.
(6) MIN.
*-C-L-
360mm MAX.
(14-3/16) MAX.
Fig. 1
Roughing-in
Dimensions
RECOMMENDED TOOLS; Fig. 2.
1. Teflon Tape
2. Flat Blade Screwdriver
3. Adjustable Wrench
4. Tape Measure
5. Hacksaw
6. Tubing Cutter
7. File
8. For Sweat Connection; Solder and Torch
9. 2.5mm Hex Wrench
10. 1.5mm Hex Wrench
GENERAL DESCRIPTION:
SELECTRONIC
®
PROXIMITY TOILET
FLUSH VALVE
Concealed Flushometer for 1-1/2"
Top Spud Fixtures
PRIOR TO INSTALLATION
Note: Prior to installing the Selectronic™Flush
Valve the following items must be installed.
1. Toilet
2. Drain line
3. Water supply line
IMPORTANT:
•
All plumbing and electrical wiring should be
installed in accordance with applicable codes
and regulations.
• The use of water hammer arrestors is strongly
recommended for commercial applications. All piping
behind the walls should be properly secured and
fastened.
• Water supply lines must be sized to provide an
adequate volume of water for each fixture.
• Flush all water lines prior to operation
(See Step 3).
Dirt and debris can cause flush valve to run continuously.
•
With the exception of Stop Valve Inlet, DO NOT
use pipe sealant or plumbing grease on any
valve component or coupling!
• Protect the chrome or special finish on the Flushometer.
DO NOT USE toothed tools on finished surfaces to install
or service these valves. Also see “Care and Cleaning”
section of this manual.
• This product contains mechanical and/or electrical
components that are subject to normal wear. These
components should be checked on a regular basis and
replaced as needed to maintain the valve’s performance.
Fig. 2
1
2
3
4
5
6
7
9
10
8
10'
M965640 Rev. 1.4 (11/17)
CAUTION: Use only American Standard
supplied transformers and cable sets.
Using non-AS supplied cables, or cutting,
splicing or modifying any components will
void the warranty.
