background image

9

8

11

3mm

HEX WRENCH

12

M 9 6 8 5 17   R E V. 1. 5

4

TEST INSTALLED FAUCET

Unthread SPRAY HOSE 

(3)

 from SPRAY 

(2)

.

Turn on water supplies and check connections for leaks

.

Hold HOSE END 

(3)

 in sink and operate HANDLE 

(1)

 on and off,

hot and cold to flush water lines thoroughly. Replace SPRAY 

(2).

 

Pull SPRAY 

(2)

 out and check hose and supply connections

for leaks.      Check that SPRAY HOSE 

(3)

 and WEIGHT 

(4)

 slide

up and down freely and do not interfear with supplies or waste

outlet plumbing. With faucet on push BUTTON 

(5)

 to spray. Move

HANDLE 

(1)

 to “off” position to return to aerator function.

 

Check all drain connections for leaks.

Move HANDLE 

(1)

 to "off" position.

1

2

5

3

3

4

Loosen and remove LEVER HANDLE 

(1).

 Loosen HANDLE

SCREW 

(2) 

with 2.5mm Hex Wrench and then pull HANDLE

BASE 

(3) 

off.

Unthread ESCUTCHEON CAP 

(4)

. Unthread the

CARTRIDGE NUT 

(5)

.

Remove CARTRIDGE 

(6)

. Clean inlets of CARTRIDGE 

(6)

and MANIFOLD 

(7)

.

Reassemble CARTRIDGE 

(6)

. Replace CARTRIDGE

NUT 

(5)

, CAP 

(4)

 and HANDLE assembly, check flow.

SERVICE

Clogged CARTRIDGE outlets or inlets may cause reduced

flow. 

To clean, first turn off water supply then:

5

6

HOT & COLD SUPPLIES

CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH  CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A

CLOTH WITH A COARSE SURFACE.

1

2

3

4

5

6

CLEAN

7

Move HANDLE 

(1)

 into "off" position.

If SPOUT (11) leaks at swivel point the O-RINGS (12) need

to be replaced. To remove SPOUT (11)

:

Disconnect SPRAY HOSE 

(8)

 from CONNECTING NUT 

(9)

.

Loosen the SPOUT SET SCREW 

(10)

 with a 3mm Hex wrench.

Rotate the SPOUT 

(11)

 side to side while pulling upward to 

remove SPOUT 

(11)

 from faucet body. Remove SPRAY HOSE 

(8)

.

Replace the defective parts and grease O-RINGS 

(12)

. Replace SPRAY

HOSE 

(8)

. Push SPOUT 

(11)

 back into position. Tighten SET SCREW 

(10)

.

Reconnect SPRAY HOSE 

(8)

 to CONNECTING NUT 

(9)

.

Check that SPOUT 

(11)

 rotates freely and does not leak

at the swivel point. 

REMOVE

INSTALL

10

Отзывы: