M 9 6 8 5 17 R E V. 1. 5
RED
STRIPE
BLUE
STRIPE
2
MAKE WATER SUPPLY CONNECTIONS
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES
(1, 2)
directly to wall supplies. Connection
on fitting supplies are 3/8" compression. Connect left supply
(Marked with a Red Stripe) to Hot and right supply (Marked with
Blue Stripe) to Cold wall supply. Use adjustable wrench to
tighten connections. Do not over tighten.
Faucet supplies are 27-1/2" long from faucet base.
Note: If additional supply length
is required, installer must
purchase additional parts
separately.
Important: If SUPPLY HOSES
(1, 2) are too long, loop as
illustrated to avoid kinking.
1
2
COLD
HOT
3
CONNECT HOSE SPRAY
and INSTALL WEIGHT
Figure 2
Check that seal washers are installed in both ends of SPRAY HOSE ADAPTER
(1).
Thread SPRAY HOSE ADAPTER
(1)
onto faucet SHANK
(2)
. Tighten with adjustable wrench.
Figure 1.
Thread HOSE END
(3)
into bottom of SPRAY HOSE ADAPTER
(1).
Tighten with adjustable wrench.
Make sure all connections are tight.
Figure 1.
Install RUBBER BUSHING
(4)
onto SPRAY HOSE
(5)
. Install WEIGHTS
(6)
onto HOSE
(5)
using two screws
(7)
. Locate
WEIGHTS
(6)
18" from underside of mounting surface on HOSE
(5)
. Tighten SCREWS
(5)
firmly.
Figure 2.
SEAL
WASHER
SEAL
WASHER
2
1
3
5
7
6
4
Figure 1
UNDER SIDE
OF MOUNTING
SURFACE
18"
