1-20
American-Lincoln
3366XP
NOTE
Before starting the engine, perform these pre-start checks.
PRE-START CHECK LIST
1.
Check engine air filter element indicator.
2.
Check engine oil level.
3.
Check radiator coolant level.
4.
Check hydraulic fluid level.
5.
Check fuel level.
6.
Check all systems for leaks.
7.
Check brakes and controls for proper operation.
8.
Check broom patterns
BEFORE STARTING ENGINE
1.
Set Parking Brake.
2.
Make sure all controls are in the “Off” position.
TO START ENGINE
1.
Be sure accelerator and directional control pedal is in neutral.
2.
Pull choke if engine is cold (Gas Engines Only.) If machine is stored in extremely cold temperatures,
(under 32° F. or 0° C.), pull choke and hold throttle open approximately halfway when starting engine.
3.
Turn key to “On” position & release. Push choke in when engine starts.
4.
If engine fails to start after following the above procedures, refer to Engine Manual Section.
NOTE
When machine has been stored in below freezing temperatures, run engine at not over 1/2 throttle with machine
standing still for 5 to 10 minutes to warm engine and hydraulic oil.
TO OPERATE SWEEPER
1.
Make sure parking brake is released.
2.
Lower the side and main broom to the floor. (The main broom control may be placed in either the
“FLOAT” or “SWEEP” position (See Figure 10).
3.
Turn Broom Fan Switch on.
4.
Pull engine throttle to “UP” position. (Engine must always be operated at full governed speed while
sweeping to obtain recommended brush speed and dust control).
5.
Push forward on directional control pedal to place machine in motion.
6.
Vary your foot pressure on the directional control pedal to obtain desired travel speed.
TO STOP SWEEPER
1.
Allow directional control pedal to return to neutral (centered) position. (Pedal will automatically return to
neutral when foot pressure is released.) FOR NORMAL OPERATION, DEPRESS DIRECTIONAL
CONTROL PEDAL WITH HEEL INTO NEUTRAL.
2.
Depress the foot brake.
3.
Turn Broom Fan Switch off.
4.
Put the broom controls (Side and Main) in the “UP” position.
5.
Push engine throttle down. Turn key to “OFF.”
6.
Set parking brake.
OPERATING INSTRUCTIONS
