1-12
American-Lincoln
3366XP
WARNING
FOR SAFETY, OBSERVE THE FOLLOWING WARNINGS. FAILURE TO COMPLY MAY CREATE A SERIOUS RISK OF
INJURY TO YOURSELF AND OTHERS. THIS MACHINE SHOULD NOT BE USED IN HAZARDOUS LOCATIONS INCLUDING
AREAS OF VOLATILE DUST OR VAPOR CONCENTRATIONS.
1. To avoid possible injury or property damage, read the operator’s manual before using the machine.
2. Fire hazard. Fine dust, fuels solvents and thinner can explode and cause severe burns.
3. Do not use with/ or near flammable materials or vapors. Use only with good ventilation.
4. Heavy machinery, Improper use can cause personal injury.
5. Operate only from the designated operators position. Keep inside the body of the machine. Keep
hands and feet on the designated controls. Always operate in well lighted areas.
6. Do not leave the machine on a ramp or dock. After stopping the machine, turn all the switches off.
7. Do not dump the hopper over an open pit or dock. Do not dump the hopper when positioned on a
grade (ramp). The machine must be level (horizontal).
8. Operate only when lids, doors, and access panels are securely closed.
9. Never travel with the hopper in the raised position.
10. The operator must exhibit extreme caution when negotiating, turning and traveling across grades or
ramps.
11. Start, stop, change direction, travel and brake smoothly. Slow down when turning. Avoid uneven
surfaces and loose materials.
12. Watch out for obstructions, especially overhead.
13. Carry no passengers on the machine.
14. Set parking brake when leaving the machine. Chock (block) the wheels if the machine is to be parked
on a grade (ramp), or is to be worked on.
15. Never leave the operator’s seat with the engine running.
16. Report damage or faulty operation immediately. Do not operate the machine until repairs have been
completed.
17. Maintenance and repairs must be done by authorized personnel only.
18. Never manually depress the electrical switch on the left lift arm when the hopper is raised.
WARNING
TO MAINTAIN THE STABILITY OF THIS SWEEPER IN NORMAL OPERATION, THE COUNTER-WEIGHTS, OVER-
HEAD GUARD, REAR BUMPER GUARD, OR ANY SIMILAR EQUIPMENT, INSTALLED BY THE MANUFACTURER AS
ORIGINAL EQUIPMENT, SHOULD NEVER BE REMOVED. IF IT BECOMES NECESSARY TO REMOVE SUCH
EQUIPMENT FOR REPAIR OR MAINTENANCE. THIS EQUIPMENT MUST BE REINSTALLED BEFORE THE
SWEEPER IS PLACED BACK IN OPERATION.
WARNING
WHEEL ASSEMBLY MAY EXPLODE CAUSING SERIOUS PERSONAL INJURY OR DEATH. WHEEL ASSEMBLY
MUST BE SERVICED BY PROPERLY TRAINED AND QUALIFIED PERSONNEL IN ACCORDANCE WITH FEDERAL
OSHA STANDARD 29 CFR PART 1910.177.<D>
WARNING
DO NOT ADD AIR TO TIRE AND RIM ASSEMBLIES THAT HAVE BEEN OPERATED IN A SERIOUS UNDERINFLATED
OR FLAT CONDITION. THE TIRE AND RIM COMPONENTS CAN EXPLODE CAUSING SERIOUS OR FATAL INJU-
RIES.
-Always deflate a tire and wheel assembly completely before removing it from the vehicle for
servicing.
-An under inflated tire is one inflated to 80% or less of recommended air pressure.
-Never use mismatched tire/rim components.
SAFETY INSTRUCTIONS