REV. 12-28-17
American Flame: E-Stop Gas Timer
Model:
ESTOP1-0H
Description
The E-Stop Gas Timer is an emergency shut-off, mechanical timer, and manual shut-off gas valve
designed to be installed on the inlet side of a gas appliance to enable the user to control the time gas is allowed to flow
to a gas appliance. This is a mechanical timer (no batteries or power required) that has the ability to control gas flow for
1-hour (60 minutes) using the ESTOP1-0H model or 2.5-hours (150 minutes) using the ESTOP2-5H model. In addition,
both models have an emergency shut-off (red knob) that enables the user to quickly and easily shut the gas completely
OFF, should the need arise.
The E-Stop Gas Timer body is 4-inches high x 2
⅞
-inches wide x 2
⅛ -inches deep
and can replace a manual shut-off
valve and meet local code requirements as the accessible shut-off valve. It can be use for multiple applications (indoor
or outdoor) from gas fire pits, gas grills, gas logs, gas torch lights, etc., wherever a shut-off valve is a requirement or a
specified by a customer.
Model:
ESTOP2-5H
E-Stop Gas Timer
A F
A M E R I C A N F L A M E
PUSH TO STOP
TURN TO START
OFF
TURN
PAST
20
40
60
MINUTES
E-STOP1-0
PUSH TO STOP
TURN TO START
OFF
0.5
HOURS
1
1.5
2
2.5
E-STOP2-5
TURN
PAST
Specifications
Pipe Size: ½” NPT (2) inlets and (2) outlets
Maximum Pressure: ½” PSI
CSA Rated Capacity: 165,000 Btu/Hr at 1” Pressure Drop (NG)
Ambient Temperature: 0°F to 175°F (79°C)
Timer Accuracy: 60 Min. +/- 15% or 2.5 Hrs.+/- 15%
Inlets: Have fine mesh screens to filter any debris
Multiple Mounting Holes: Uses 3/16-24 machine threads
Designed For: Natural or LP Gas (no conversion required)
CSA Certified: Tested to ANSI Z21.21; CSA 6.5
WARNING
• Read these instructions carefully. Failure to follow these instructions completely could damage the product or cause
a hazardous condition.
• Check the ratings given in the instructions and on the product your installing to make sure the E-Stop Gas Timer is
suitable for your application. See description below.
• Installer must be a trained, experienced service technician or gas plumber.
• After installation is complete, check out product operation as provided in these instructions.
