18
CLEANING THE GLASS
When the fire is first started, it will produce some smoke. The smoke might accumulate on the glass
surface. Before the fire gets hot, open the door and wipe the glass surface off with a damp rag. Do not
touch the surface with your hands. If after constant use, the glass is dirty; you must clean the glass so that
it will not become etched with the fly ash. When the glass has cooled off, take a damp rag, put a little fly
ash from the unit on it and clean the glass. If this does not clean the glass use a special glass cleaner
provided by your
Avent Wood Pellet
reseller.
We have found that Amway crème glass & chrome
cleaner works real well.
Manual Combustion air slide
(pushing in the slide decreases the
combustion air, pulling out increases
the combustion air to the fire)
Room/Combustion air inlet
Outside Air 3” dia. Hookup tube
110V
AC
power
cord
STOVE CONTROLS
GLASS CLIPS
12 volt DC wiring installation
The Avent pellet stove is designed to operate on a
12 volt DC battery system for extended back-up
periods. This system may also be used in
conjunction with 12 volt solar systems.
WARNING: THE STRUCTURAL
INTEGRITY OF THE HOME MUST BE
MAINTAINED IF INSTALLING THIS
SYSTEM.
Disconnect 110 power source before connection of
12 volt dc battery. Determine proper length of 18
gage stranded wire to run from battery to unit.
Install ½” conduit if passing through a wall or floor.
Connect Red 18 gauge stranded wire to red (+)terminal
and Black 18 gauge stranded wire to black (-) terminal
on back of stove. Pass wires through conduit leaving
room for a drip loop between connections so that
moisture will not get on connections. Install a 4 amp
inline fuse on the red (+) lead near the battery. Connect
the red (+) lead to the positive terminal and the black (-)
lead to the negative terminal on the battery. Reconnect
the 110 power source and the unit is ready to operate.
The system will switch between 12 volt and 110 volt and
charge the battery automatically.
Back of
unit
12V DC
connections
