SPEEDDOME ULTRA OUTDOOR HOUSING
8200-0184-10, REV. C
CONTINUATION OF INSTALLATION GUIDE
8 of 12
Housing Termination
Both the outdoor housing and dome
camera are shipped “terminated” for when
they are installed at the end of a data
cable. Should the cable continue to
another dome, “unterminate” the housing
using the procedure opposite.
IMPORTANT!
Leave the dome camera set
to “terminated”.
Unterminating the Outdoor Housing
CAUTION:
The environmental circuit board inside
the housing is static sensitive! Touch the metal
housing to discharge it before touching the board.
1. As shown above, detach the circuit board from
the housing by:
A) Pushing fingers molded into the base away
from the board while
B) Pulling on the dust cover protecting the
board’s spring finger connector.
Note:
Keep the dust cover in place for the
next two steps.
2. On the top side of the circuit board, place
jumper E1 across pins 1–2 for “unterminated”.
3. On the circuit board is a mark. To reattach the
board to the housing, center the mark between
fingers on the base and snap the board in
place.
4. Gently remove the dust cover.
Note:
Keep the cover and use it to protect
contacts should the environmental PC board
need to be removed from the housing.
1
2
3
4
A
B
