MEGAPOWER CPU ETHERNET FIRMWARE UPGRADE PROCEDURE
8200-0813-01, REV. B0
INSTALLATION GUIDE
8 of 12
Figure 17. Directory screen
14. At the Command Prompt, type
tftp –i
, the
MPCPU IP address,
put
, and the previously
displayed filename to send the FPGA file
(
mpcpuV
xxxx
.pga
) to the MPCPU.
Be sure to include the “
–i
” (minus, lowercase
letter “I”) format identifier. After each file is
transmitted, a “transfer successful”
confirmation line is displayed. Example of the
tftp command:
C:\Documents and Settings\MPCPU_Upgrade
>
tftp –i 192.168.0.19 put mpcpuVxxxx.pga
Figure 18. Updating the FPGA file
15. At the Command Prompt, type
tftp –i
, the
MPCPU IP address,
put
, and the previously
displayed filename to send the boot file
(
mpcpuV
xxxx
.umb
) to the MPCPU (see
Figure 19).
Be sure to include the “
–i
” (minus, lowercase
letter “I”) format identifier. Example of the tftp
command:
C:\Documents and Settings\MPCPU_Upgrade
>
tftp –i 192.168.0.19 put mpcpuVxxxx.umb
Figure 19. Updating the boot file
16. At the Command Prompt, type
tftp –i
, the
MPCPU IP address,
put
, and the previously
displayed filename to send the application file
(
mpcpuV
xxxx
.ump
) to the MPCPU.
Be sure to include the “
–i
” (minus, lowercase
letter “I”) format identifier.
Example of the tftp command:
C:\Documents and Settings\MPCPU_Upgrade
>
tftp –i 192.168.0.19 put mpcpuVxxxx.ump
Figure 20. Updating the application file
17. Type
exit
to end the Command Prompt
session.
C:\Documents and Settings\MPCPU_Upgrade
>
exit
Figure 21. Exiting the command prompt
18. Reset the power or press the recessed front
panel reset to activate the firmware upgrade.
As the MPCPU reinitializes, it should