Intellex RMS Digital Video Management System
3
Connect the Cameras
Connect the video cables from the cameras to the BNC connectors on the rear of the RMS
(#12 in Figure 1 below). Terminate the video using the switches at each BNC connector
or using the Intellex Setup screen. If you use the switches to select the
75 Ohm
termi-
nation, you MUST select
Hi-Z
in the Intellex Setup screen. If you wish to use the Intellex
Setup screen to select the
75 Ohm
termination, you MUST set the switches at each BNC
to Infinity
(
∞)
.
Connecting the Power
Connect the provided power cable to the power entry connector on the RMS (#3 in
Figure 1). BE SURE TO SELECT THE CORRECT VOLTAGE (#2 on Figure 1) BEFORE
CONNECTION TO THE POWER SOURCE. The RMS will start running as soon as the
power source is connected.
Rear Panel
Figure 1 —Rear Panel Connectors
Rear Panel Connectors
1. Master Power Switch
—
This switch turns the unit on and off.
2. Power Setting
— Use this switch to select the correct input voltage setting: 115 or
230 volts.
