ADC780 SERIES VANDAL-RESISTANT CAMERA
8000-2811-01, REV. C1
INSTALLATION AND SETUP GUIDE
4 of 11
Flush Mount Installation
(In a wall or ceiling)
1. Loosen (DO
NOT
REMOVE) four captive Torx
screws to remove the cover from enclosure.
2. Using the mounting plate as a template, cut a
round opening in the wall or ceiling. Then, using
the four anchors and screws supplied, center
the gasket over the opening and attach it to the
ceiling.
3. Run 24vac and video cables through the
opening in the ceiling. Then attach the
enclosure to the gasket using screws shown.
Apply power to the camera.
4. Holding the yoke (not the camera lens barrel),
swivel the camera to adjust (using a small
screwdriver) the auto-iris level control on the
edge of the top board.
5. Swivel the camera to adjust the ac phase
control on the edge of the bottom board.
6. Select DIP switch settings (page 8).
7. Holding the yoke (not the camera lens barrel),
swivel the camera to the desired view.
Caution:
DO NOT point the camera directly at
the sun’s path.
8. Adjust zoom and focus arms on the lens barrel
to the desired setting and tighten them in place.
9. Tighten the two yoke screws and reattach the
cover on the enclosure using the four Torx
screws.
M4 x 8 Pan Head
Screws (2x)
Rubber
Washers (2x)
FC1 M4 x 20 Flat
Head Screws (4x)
M4 Plastic
Anchors (4x)
