ADC780 SERIES VANDAL-RESISTANT CAMERA
8000-2811-01, REV. C1
INSTALLATION AND SETUP GUIDE
3 of 11
4. If using the camera outdoors, see “Heater
Installation”, page 7.
5. Run 24vac and video cables to the enclosure.
Connect cables where shown and apply power
to the camera.
6. Holding the yoke (not the camera lens barrel),
swivel the camera to adjust (using a small
screwdriver) the auto-iris level control on the
edge of the top board.
7. Swivel the camera to adjust the ac phase
control on the edge of the bottom board.
8. Select DIP switch settings (page 8).
9. Holding the yoke (not the camera lens barrel),
swivel the camera to the desired view.
Caution:
DO NOT point the camera directly at
the sun’s path.
10. Adjust zoom and focus arms on the lens barrel
to the desired setting and tighten them in place.
11. Tighten the two yoke screws.
12. If the humidity is high at the time of installation,
place the bag of desiccant inside the enclosure.
13. Reattach the cover on the enclosure using the
four Torx screws.
14. Place a bead of Silicone caulk everywhere
where the corner mount meets the wall.
Swivel camera
holding yoke
Auto-Iris Level
Adjustment
AC Phase
Adjustment
Focus
Zoom
DIP Switch
Yoke
Screws (2x)
Video Connection
AC Terminal Block
AC Camera
Connection
