American Dynamics AD1684B, Руководство по установке

Страница: 15 / 28

AD1684B CONNECTIONS
Auxiliary Connections
The Receiver connection of auxiliary equipment is with a ten
(10) pin connector, labeled J6, located on the right side of the
PCB (see Figure 1, page 2). When the Receiver is setup for
auxiliary (see Setup, page 2), the J6 connector is for Auxiliary
functions, and only one Pan/Tilt can be connected, to the J7
connector. Table 6 lists the pin designations from the Receiver
to the auxiliary and provides space for the installer to record
the pinouts for the specific installation.
The connector terminals accept wire gauge sizes from 22-
AWG to 14-AWG, stripped 1/4" (6mm) from the end.
BEFORE STARTING:
1. Check power line to verify that power is off.
2. Open the Receiver and locate the Auxiliary connector J6,
located on the PCB near the right side of the unit.
WIRING INSTRUCTIONS:
3. Pass the wire through the bushing to the Auxiliary
connector, do not tighten bushing.
4. Strip the ends of auxiliary wires.
5. Insert the Hot wire of the Auxiliary into the screw-terminal
connector pin location for the appropriate auxiliary action.
6. Insert the Return wire of the Auxiliary into the terminal pin
location for the auxiliary voltage, 24VAC Common.
Note: DO NOT CONNECT THE 24 VAC AUXILIARY
COMMONS TO THE 120 VAC COMMONS.
7. Repeat steps 3 through 6 for each Auxiliary (Aux 1, 2, 3,
and 4).
8. Remove any excess cable and tighten the bushing.
9. Insert the screw-terminal connector into the J1 connector.
9
Table 6 - Single Pan/Tilt and Auxiliary 10-pin Connector Pinout
Channel A - J7
PIN No. FUNCTION Pan/Tilt PINOUT LENS PINOUT
01 Focus __________________ __________________
02 Zoom __________________ __________________
03 Iris __________________ __________________
04 DC Ground __________________ __________________
05 24 VAC Common __________________ __________________
06 Tilt Down __________________ __________________
07 Tilt Up __________________ __________________
08 DC Ground __________________ __________________
09 Pan Right __________________ __________________
10 Pan Left __________________ __________________
Auxiliary - J6
PIN No. FUNCTION Pan/Tilt PINOUT LENS PINOUT
01 No Connection __________________ __________________
02 No Connection __________________ __________________
03 No Connection __________________ __________________
04 No Connection __________________ __________________
05 24 VAC Common __________________ __________________
06 Auxiliary 2 __________________ __________________
07 Auxiliary 1 __________________ __________________
08 No Connection __________________ __________________
09 Auxiliary 3 __________________ __________________
10 Auxiliary 4 __________________ __________________