3
BULB REPLACEMENT
BULB REPLACEMENT
Before servicing the Illuminator, power down the unit and
allow approximately one hour to cool. Replacement bulbs can
be ordered through American Dynamics (part #
AD1010/TBB). IR bulb replacement is done without
removing the Illuminator from its mount.
• Remove the three 4 mm Hex screws holding the main
housing to the rear housing (see Figure 3).
• Pull the defective IR bulb forward and gently remove the
power cord connector from the IR bulb prongs.
• Remove and save the O-Ring (red colored gasket) around
the defective bulb.
• Discard the defective bulb.
• Fit the O-ring (red colored gasket) around the new IR bulb
and plug in the power cord connector taking care not to
crack the porcelain base of the connector.
• Check that the IR bulb O-Ring is properly seated between
the new bulb and the rear housing. Refer to Figure 3.
• Check that the weather seal (black colored gasket) is
properly seated in the rear housing outer rim.
• Insert the IR lamp into the main housing.
• Close the housing and secure the three 4 mm Hex screws.
AAAAA
AAAAA
AAAAA
AAAAA
AAAAA
AAAAA
AAAAA
AAAAA
Main Housing
Rear Housing
AAAAAAAA
AAAAAAAA
AAAAAAAA
AAAAAAAA
AAAAAAAA
AAAAAAAA
AA
AA
AA
AA
AA
AA
AAA
AAA
AAA
4mm
Hex
Screw
Replacement Bulb
Power Cord
w/Connector
AAA
AAA
O-Ring
Weather Seal
AA
AA
AA
A
A
A
AA
AA
Figure 3 - Bulb Replacement
IF YOU ENCOUNTER ANY PROBLEMS
OPERATING THIS UNIT, OR NEED TECHNICAL
ASSISTANCE, CALL OUR TECHNICAL SUPPORT
CENTER AT:
within the United States: 1-800-442-2225
outside the United States: (914) 624-7640
