11
1. Leveling Dryer
To level dryer, place 4-inch square metal shims (refer to the illustration on
page 10
) or other suitable material
under the base pads. It is suggested that the dryer be tilted slightly to the rear. If more headroom is needed
when moving dryer into position, the top console (module) may be removed.
a. To remove top console (module).
NOTE
:
DO NOT
have power connected when separating the top console.
1) Disconnect the ground wire at the rear of dryer.
2) Remove the six (6) sets of nuts and washers (B) holding the console (module) to base. (Located with-
in control boxes)
3) Open control door and control panel then disconnect the following:
(a) On the right side box, disconnect the 4-pin and 2-pin plug. Also remove the air connection at the
union.
(b) On the left side box, disconnect the drive and blower motor wires, along with the two (2) "red" and
"black" wires.
4) Lift the console (module) off of the dryer base.
IMPORTANT
: The dryer
must be
transported and handled in an upright position at all times.
