9
OPTIONAL SHAMPOO SHELF INSTALLATION
TIME REQUIRED
1/2 - 1 HR
12
4. On the 2 tiles the Shampoo Shelf will be replacing, mark 1”
from the outside of the grout line, the cut-out area will be
10” x 22”. Cut out the hole for the Shelf. The smaller the
hole the better.
5. Dry-fit the Shampoo Shelf for alignment of grout lines.
6. Silicone in-place with a generous bead around the back of the
lip, wipe off excess silicone with tissue.
1. The Shampoo Shelf was designed to match your tile size.
(2) 12” x 12” tiles, the cut-out hole size is 10 x 22”.
2. There is a 1” lip or frame around the Shampoo Shelf, this will
be the water sealed area for the Shampoo Shelf.
3. The best way to cut the hole is with a small 5” round
diamond blade, and with a jigsaw to cut the corners.
See detailed instructions enclosed with Shampoo Shelf
GLASS DOOR & PANEL INSTALLATION (if ordered)
13
diagram 17
Note: Two people are required for this installation. Take careful measurements before
cutting or drilling products.
A - Handle Installation
1. Set the glass door in a position to enable the assembly of the handle.
(diagram 16)
2. Loosen the set screws so you can separate the handles.
3. Unscrew the long bolt from the handle. Keep all rubber pieces attached to the screw.
4. Remove the first set of flat, clear washers from the bolt.
5. Start with the top hole on the glass door. Place the long bolt through the hole in the door
(keeping the remaining rubber pieces on the bolt). On the other side of the glass place the flat
washers onto the threaded portion of the bolt.
6. Take one side of the handle and screw the long bolt into the end. Just start the bolt until a few
threads catch. Keep loose.
7. Put the second bolt through the lower hole. Place the flat washer onto the bolt. Screw the bolt
into the bottom handle.
8. Align the handle on the door and carefully tighteb the long bolts. Do not over tighten.
9. Place the opposite handle over the long bolts and tighten the set screws to secure the handle.
B - Hinge Installation
1. Locate the top hinge and remove the side plate by loosening the two screws.
(diagram 17)
2. Place the hinge into the top cutout on the door so the screws will be facing into the shower
and install the side plate. Tighten the screws until the hinge is secure. Make sure the hinge is
centered in the cutout and that the screws are facing into the shower.
Be careful not to rest the edges of the door on hard
surfaces. Tempered glass is very strong and impact
resistant but its weakest point is impact on the edges.
diagram 16
clear washer
clear spacer
clear washer
set screw
shower
inside
shower
outside
hinge pin
side plate
screws
door
