allowing for a maximum midrange gain of 12dB or maximum decrease of -30dB. Turning the knob in a
counter-clockwise direction will decrease the amount of midrange applied to a channel signal, turning
the knob in a clockwise direction will increase the amount of midrange applied to a channel signal.
5.
CHANNEL BASS CONTROL -
This knob is used to adjust the low frequency levels of a channel
allowing for a maximum bass gain of 12dB or maximum signal decrease of -30dB. Turning the knob
in a counter-clockwise direction will decrease the amount of bass applied to a channel signal, turning
the knob in a clockwise direction will increase the amount of bass applied to a channel signal.
6. MASTER OUTPUT BALANCE CONTROL -
This knob is used to control the pan, adjust how much
of the signal is sent to the left and right output level. For true stereo imaging, maintain the knob in the
12 o’ clock position.
7. ZONE LEVEL VOLUME OUTPUT CONTROL -
This rotary knob is used to control the zone level
volume. The zone level is not PFL, it is essentially a second master output volume with separate out-
put volume control.
8
.
ZONE TREBLE CONTROL -
This knob is used to adjust the low frequency levels of the
ZONE allowing for a maximum bass gain of 12dB or maximum signal decrease of -12dB. Turn-
ing the knob in a counter-clockwise direction will decrease the amount of bass applied to the
ZONE signal, turning the knob in a clockwise direction will increase the amount of bass
applied to the ZONE signal.
9
.
ZONE BASS CONTROL -
This knob is used to adjust the treble levels of the ZONE allowing
for a maximum treble gain of 12dB or maximum decrease of -12dB. Turning the knob in a
counter-clockwise direction will decrease the amount of treble applied to the ZONE signal,
turning the knob in a clockwise direction will increase the amount of treble applied to
the ZONE signal.
10. MASTER OUTPUT MONO/STEREO SWITCH -
This switches the Master Output signal between
stereo and mono.
11. LCD SCREEN - FOR INFORMATION SEE PAGES 15-17.
12. DSP EFFECTS (DIGITAL SIGNAL PROCESSING) - FOR INFORMATION SEE PAGES 15-17.
13. SPLIT CUE -
This button will activate the "Split Cue" function. When used with a set of stereo
headphones, the Split Cue function will assign the Cue signal to the left channel of the headphones
and the Program (main output) signal to the right channel of the headphones. Essentially splitting the
cue signal in half. This process will allow for headphones mixing. The
CUE MIXING CONTROL (17)
will
also work in conjunction with function. Please note that this function will only work with a set of stereo
headphones.
14. HEADPHONE JACK -
This jack is used to connect your headphones to the mixer allowing you to
monitor the cue source. Use headphones only rated at 8 ohms to 32 ohms. Most DJ headphones are
rated at 16 ohm, these are highly recommended. Always be sure the
CUE LEVEL VOLUME (15)
is set
to minimum before you put the headphones on.
15. CUE LEVEL VOLUME CONTROL -
This knob is used to adjusts the headphone volume output
level. Turn the knob in a clockwise direction to increase the headphone volume.
16. CROSSFADER FX ACTIVATOR -
When this button is activated it transfers control of the the
DEPTH FEEDBACK DIAL
(65) to the
CROSSFADER
(21).
While this function is engauged the
DEPTH
FEEDBACK KNOB
(65) will not function.
When this function is engaged, you are not able to store
pre-set parameters.
Q-FX19™
CONTROLS AND FUNCTIONS cont.
©
American Audio
®
- www.americanaudio.us - Q-FX19™ Instruction Manual Page 9
