©
American Audio
®
- www.americanaudio.us - M2436FX Instruction Manual Page 15
37. REC OUT JACKS -
These jacks send the PRE FADER signal from master bus to a tape deck
for recording.
38. GROUP OUT (1-4) JACKS -
These unbalanced 1/4” TRS phone type jacks output the gROUP
1-4 signals to the input of a MTR, mixer, or other device.
39. CONTROL ROOM OUTPUT JACKS -
These unbalanced 1/4” TRS phone type output jacks
send the mixed signal to a monitoring system. Use the CONTROL ROOM/HEADPHONE CONTROL
to adjust the output signal level.
NOTE:
The signal monitored by these jacks is select by the using the LEVEL METER SIgNAL
bUTTONS, the TAPE IN CONTROL and the PFL bUTTON on the input channels.
40. HEADPHONE JACK -
Use this jack to connect headphones to the mixing board.
NOTE:
The signal monitored by these jacks is select by the using the LEVEL METER SIgNAL
bUTTONS, the TAPE IN CONTROL and the PFL bUTTON on the input channels.
41. MAIN L/R OUTPUT JACKS -
These unbalanced 1/4” TRS phone type jacks deliver a stereo
output signal to a amplifier or powered speakers. You can also use these outputs to send a signal
you wish to record. You can control the signal level control using the MAIN FADER located in the
MASTER CONTROL section.
42. FOOT SWITCH JACK -
You can connect a foot switch to this jack, and use the foot jack to
toggle the digital effects on/off.
43. AUX 1, AUX 2, JACKS -
AUX 1 & AUX 2 -
These 1/4” output jacks send a signal from either AUX 1 or AUX 2 bus to a cue
box, effector, or other monitoring system.
EFX -
This unbalanced phone output jack sends a signal to an external effect machine.
44. STEREO RETURN L (MONO) -
These are unbalanced 1/4” TRS phone-type line input jacks. The
signal received by these jacks is sent to the MAIN bus and AUX1/AUX2 buses. These jacks are
typically used to receive a return signal from an external effector (reverb, delay, etc.)
45. CHANNEL INSERT I/O JACK -
These are 1/4” TRS (tip, ring, sleeve) phone jacks that support
bi-directional operation. These input/output jacks are located between the head-amplifier and the
high pass filter. These jacks can be used to independently connect these channels to devices such
as graphic equalizers, compressors, and noise filters.
NOTE:
Connection to an I/O jack requires a special separately-sold insertion cable. Please see the
illustration below.
M2436FX
CONTROLS aNd FUNCTiONS cont.
Tip:Output(Send to external device)
Sleeve:Ground
Ring:Input(Return from external device)
INPUT/OUTPUT (I/O) JACk
