27
SVM Mode
Use this item to enable or disable CPU virtualization.
C6 Mode
Use this item to enable or disable C6 mode.
►
SATA Configuration
Press [Enter] to view current working SATA device information.
►
USB Configuration
Press [Enter] to make settings for the following sub-items:
USB Configuration
Legacy USB Support
Use this item to enable Legacy USB Support.
The optional settings are: [Enabled]; [Disabled]; [Auto].
[Enabled]:
To enable legacy USB support.
[Disabled]
: To keep USB devices available only for EFI specification,
[Auto]:
To disable legacy support if no USB devices are connected.
EHCI Hand-off
This is a workaround for OSes without EHCI hand-off support. The EHCI
ownership change should be claimed by EHCI driver.
The optional settings are: [Disabled]; [Enabled].
USB Mass Storage Driver Support
The optional settings are: [Disabled]; [Enabled].
USB hardware delays and time-outs:
USB transfer time-out
Use this item to set the time-out value for control, bulk, and interrupt transfers.
The optional settings are: [1 sec]; [5 sec]; [10 sec]; [20 sec].
Device reset time-out
Use this item to set USB mass storage start unit command time-out.
The optional settings are: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor.
The optional settings: [Auto]; [Manual].