63
•
QR Code
–
Quick Response code is a type of digital barcode that enables devices to share complex
data strings quickly.
•
Record Delay
–
Record Delay specifies in seconds how long the delay between alarm activation and
recording should be.
•
Relay Out
–
Relay Out triggers a connected alarm (connected to the alarm port on the back of the
camera) when an alarm on the camera is triggered.
•
S/N
–
S/N stands for serial number. The S/N is unique to each camera and can be used to connect to
different Amcrest apps and services to provide different methods of access to the camera.
•
Sensitivity
–
Sensitivity is the amount of change required to increase the motion detected by a
percentage. The lower the sensitivity, the more movement is required to trigger an alarm.
•
SMTP
–
Simple Main Transfer Protocol is an Internet standard for electronic mail (e-mail)
transmission.
•
Static IP
–
An IP address that does not change.
•
Sub Stream
–
Sub Stream is an alternative streaming protocol for the camera. Sub stream uses less
bandwidth and attempts to keep fluency high at the expense of quality.
•
Subnet Mask
–
a 32-bit number that masks an IP address, and divides the IP address into network
address and host address.
•
TCP/IP
–
TCP/IP stands for Transmission Control Protocol/Internet Protocol and it is the
language/protocol that allows communication between internet connected devices, whether on a
local network, or a on the Internet at large.
•
Threshold
–
Threshold is the level that the motion detection needs to reach to trigger an alarm.
•
UPnP
–
UPnP stands for Universal Plug and Play, and it is a protocol used to easily connect devices to
the internet.
•
Video Tamper
–
Video Tamper refers to any major changes happening to the video feed such as it
being blocked out, interfered with, or disconnected.
FCC Statement
1.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
2.
The user’s manual or instruction manual for an intentional or unintentional radiator shall caution
the user that changes, or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. In cases where the manual is
provided only in a form other than paper, such as on a computer disk or over the Internet, the
information required by this section may be included in the manual in that alternative form,
provided the user can reasonably be expected to have the capability to access information in that
form.
3.
(b) For a Class B digital device or peripheral, the instructions furnished the user shall include the
following or similar statement, placed in a prominent location in the text of the manual: NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that