Ambirad Vision VSO Series, Руководство по сборке и инструкция, Страница: 9 / 20

Doc No. 700021 Page 9 of 20
2.2.8 Insulation mats.
Using the recommended safety equipment i.e.
gloves, goggles and a face mask, cover the
back of reflectors with the insulation mats. Tuck
in the edge of the mat behind the lip of the
reflector.
The insulation mats come in two sections for the
four module variants.
5. Locate the M8 bolts on third bracket on this
half to slot in same reflector approx one third
distance from reflector end. Secure using large
washers and anti vibration nuts.
Now working on the second half:
6. Place the remaining inner reflectors (H) on
the heater by sliding the reflectors between the
tubes and the brackets.
7. Locate the fourth reflector onto the M8 bolts
of the first bracket on this half using the slot
approx one third distance in from the end of the
reflector. Secure using large washers and anti
vibration nuts.
8. The last slot in other end of this reflector
should align with M8 bolts on the second
bracket on this half.
9. Locate the fourth reflector onto the same bolts
using the FIRST slot in from the end and
OVERLAP the third reflector. This should create
a 84mm overlap. Secure using large washers
and anti vibration nuts
10. Locate the M8 bolts on last bracket to slot in
fourth reflector approx one third distance from
reflector end. Secure using large washers and
anti vibration nuts.
11. Slight re-adjustment of brackets may be
necessary for reflector alignment. Ensure ‘U’
bolts are tightened correctly as described in
section 2.2.3.
Final fixings for four module units.
12. At this stage, with the bellow couplers
already affixed to one half, align and offer other
side of bellow couplers to adjoining tubes,
carefully overlapping the second reflector to the
third to create a 50mm overlap. Secure using
bolts, large washers and anti vibration nuts.
13. Tighten bellow couplers as stated in section
2.2.5
14. With the assembly correctly fitted, a gap of
1120mm between brackets 3 and 4 should be
apparent.
Note: Third reflector ONLY is turned
through 180° to all other reflectors.
Ensure the 2nd reflector sits on top
of the 1st.
Ensure the 4th reflector sits on top of
the 3rd.