Ambirad VCLUS 100-S30, Установка, эксплуатация и обслуживание, Страница: 22 / 52

Doc No 700111 (06-15), Page 22
These overlapped reflectors are allowed to
‘float’ within the support bracket by leaving a
minimum of 1/8” gap of the fixing screws before
tightening the locknuts.
These are known as ‘slip’ overlaps.
Further
reflectors are assembled and
overlapped onto the emitter tube by alternating
‘non-slip’ and ‘slip’ until complete length is
covered.
Continue this method to the final reflector/
support bracket.
2.2.6 End Caps
Position an end cap beneath the reflector
profile (where required) with the end cap
flanges facing inwards. Fasten to reflector
using the four ’Z’ clips.
2.2.5 Reflectors.
After removing the coloured protective plastic
coating (where fitted), slip the reflectors through
the suspension brackets until they overlap each
other.
The first two reflectors are assembled and
overlapped by a pre determined distance, as
shown on the assembly drawing, and are fixed
onto the emitter tube using the reflector support
bracket part #L201008-SUB-SS.
Reposition the reflector support bracket if
necessary then tighten the clamp bolt.
These two reflectors are fixed in place by
tightening the fixing screws/locknuts as below.
These are known as ‘non-slip’ overlaps.
The next reflector is assembled and overlapped
by the pre determined distance. The reflector is
fitted onto the emitter tube using another
reflector support bracket #L201008-SUB-SS.
Reposition the reflector support bracket if
necessary, then tighten the clamp bolt.
All reflectors must be positioned/
attached to the brackets exactly as
detailed in the assembly drawings.
Each reflector must
OVERLAP
the
previous one as indicated by their
individual assembly sheets.
TIGHTEN SCREWS
TO FIX REFLECTOR
LEAVE
1
8
" MIN GAP TO
ALLOW REFLECTOR TO SLIDE
1
8
" min
End Cap
Burner
Reflectors. Note: each reflector must overlap the previous one
Suspension Bracket
part #L201020-SS
and fixing #L201021-SUB-SS
Support Bracket
part #L201008-SUB-SS
non-slip overlap
Support Bracket
part #L201008-SUB-SS
slip overlap
Support Bracket
part #L201008-SUB-SS
non-slip overlap
Further reflectors to be
overlapped in the same method
Subsequent support brackets to
be alternating 'slip' and 'non-slip'
2/0 GA CHAIN
(TWISTED LINK, PLATED)
NOTE.
HOOKS ARE TO
BE CLOSED UP
AFTER ASSEMBLY