Ambirad VCLUS 100-S30, Установка, эксплуатация и обслуживание, Страница: 20 / 52

Doc No 700111 (06-15), Page 20
Fit three turbulator strips here
Vent
Vent
Fit the remaining turbulator strips here
Slide the connected sections into the emitter
tube(s). Add further strips to form the correct
length required.
2.2.2.2
Where a heater configuration requires more
than three turbulator strips and has the exhaust
heat exchanger tube adjacent to an “L” or “U”
heat exchanger tube, refer to the diagram below
for positions.
For specific configurations see detailed
assembly diagrams on pages 26 to 37.
2.2.2.2 Burner Inserts
The burner insert (when required) is inserted
into the first heat exchanger emitter tube from
where it is joined to the second emitter tube.
2.2.3 Brackets
There can be various styles of brackets
supplied with these heaters:
2.2.3.1 Suspension Brackets
2.2.3.1.1 Fixed suspension bracket assembly
part #L201020-SS & tube straps part #L201021-
SUB-SS
ONLY
used as the first suspension
bracket positioned
CLOSEST TO THE
BURNER.
PARTS #L201020-SS plus #L102021-SUB-SS
TUBE
STRAP
RADIANT
TUBE
SUPPLIED
NUT & BOLT
SUSPENSION
BRACKET
"A"
VIEW ON "A"
Slip the suspension first bracket assembly - part
#L201020-SS onto the first section of emitter
tube in the position as indicated on the
assembly drawing.
Locate the tube strap assembly part #L201021-
SUB-SS and loosen the nut and bolt.
Position the strap over the emitter tube and
hook the two straps onto the suspension
bracket.
Finally tighten the nut and bolt to secure the
bracket onto the emitter tube.
2.2.3.1.2 Suspension brackets #L201020-SS
with no tube straps. For
ALL
other suspension
brackets
Once the emitter tubes have been assembled
using the couplers (see section 2.2.4), position
all other suspension brackets part #L201020-SS
onto the tube(s) in their relevant positions as
shown on the assembly drawing.
PART #L201020-SS
RADIANT
TUBE
SUSPENSION
BRACKET