Version 1.0
©Copyright 2014, Ambient LLC. All Rights Reserved.
Page 37
Note:
The purpose of calibration is to fine tune or correct for any sensor error associated with the
devices margin of error. Errors can occur due to electronic variation (example, the temperature sensor
is a resistive thermal device or RTD, the humidity sensor is a capacitance device), mechanical
variation, or degradation (wearing of moving parts, contamination of sensors).
Calibration is only useful if you have a known calibrated source you can compare it against, and is
optional. This section discusses practices, procedures and sources for sensor calibration to reduce
manufacturing and degradation errors. Do not compare your readings obtained from sources such as
the internet, radio, television or newspapers. The purpose of your weather station is to measure
conditions of your surroundings, which vary significantly from location to location.
6.6
Factory Default
Enter the Factory Default Mode
Figure 30
Select
Setting
Select
Setting
Scroll left
Scroll
right
Scroll field
up
Scroll
field
down
Enter
sub-setup
mode
return
to home
1.
Re-register Transmitter Indoor.
Re-synchronizes the wireless signal from the indoor
thermo-hygrometer-barometer. Press
to highlight this field.
Press
or
key to select re-register indoor transmitter. Press
or
key to
popup the
Message Box
”Are you sure you want to register the new indoor transmitter?”
