Version 1.4
©Copyright 2015, Ambient LLC. All Rights Reserved.
Page 16
8.7
Smart Phone and PDA Operation
Because smart phone batteries vary in their current ratings, we cannot specify charging rates or usage
time. 10 to 15 minutes of cranking may result in 1 or more minute of talk-time, but your results may
vary.
To charge the smart phone or music player device:
1.
Disconnect the unit from AC or USB power (if it is connected).
2.
Press and hold the Power button
for 3 seconds until the
PHONE
charging icon is
displayed on the screen. This feature will turn off all radio modes to conserve power.
3.
Lift the rubber tab on the back of the WR-335 to expose the connectors, as shown in Figure 2.
4.
Plug the smart phone charging cable (your own that came with your phone or PDA, or the
10-in-1 cable included) into the WR-335 charge USB output (Figure 2 reference 20). Plug
your smart phone or PDA cable into the USB power output port.
5.
If the phone does not begin charging, disconnect the phone and begin cranking. When
charging a smart phone via the smart phone charger, it is important to turn the crank at least
two revolutions per second. After two minutes of cranking at two revolutions per minute, wait
two minutes to begin cranking again. This will extend the crank life.
NOTE:
You may receive a charging compatibility error on your smart phone, but your device may
still charge and it will not harm your device.
8.8
Low Battery Indication
When the battery voltage is less than 3.0V, the low battery indication will be displayed:
The ADVENTURER2 will not operate in a low battery condition. If the battery drains quickly, or the
charging LED flashes rapidly from red to green, it is time to replace your battery (typically 1-3 years
of operation).
8.9
Audio Output / Head Phones
The WR-335 includes an audio output jack. This allows you to listen with headphones or connect to
an auxiliary input source, such as an amplifier.
CAUTION
: Guard your ears against hearing damage. When listening with headphones, start at the
lowest volume and gradually increase until you can hear it comfortably and clearly.
Read this Important Information before Using Your Earbuds:
Avoid extended play at very high volume as it may impair your hearing.
If you experience ringing in your ears, reduce the volume or shut off the ADVENTURER2.
Keep the volume at a reasonable level even if your headset is an open-air
type designed to allow you to hear outside sounds. Please note that
Excessively high volume may still block outside sounds.
8.10
Audio Input
You can connect and play music from external PDAs and smart phones, including IPods and IPhones.
Connect the external device using a 3.5mm audio cable.
